Today I found a new thing about the iphone services and I wanted to share it with you. As you know that the way of sending the messages whether SMS or MMS in iPhone are from a single location the (messages) and the the iPhone its self determines whether the message is to be sent as SMS text or as MMS (if there is an image in the message). But it is very hard to know how to configure our mms setup to make it able to send and receive mms . Well I JUST found out about that and here is the way :

Go to Setting ---- general-----NETWORK----- CELLULAR DATA NETWORK ;look below "mms" and put your service provider SETTING , here are the one for the STC ( Saudi Telecom) FOR other service providers you might find the setup infos at this link.

STC SETTINGS:
There are several setting , all are working but if you had any problem may because the connection is temporary not available so try another time within 2 minutes. I f after 2 minutes it did not work change the setting to the next one

setting 1

• in APN put mms.net.sa
• leave user name and password field as blank ,(do not put anything )
• in MMSC write mms.net.sa:8002
• MMS Proxy write 10.1.1.1:8080

setting 2

• APN mms.net.sa
• MMSCmms.net.sa:8080
• PROXY 10.1.1.1:8080

setting 3

• APN mms.net.sa
• MMSC mms.net.sa:8002
• proxy 10.1.1.1:8080
• user : pps
• password : pps

setting 4

• APN mms.net.sa
• MMSC mms.net.sa:8002
• proxy mms.net.sa:8080
• user : wag
• password :1234

Then reboot your iPhone by holding the power button until the red arrow appears then ,slide it to power off,.

AFTER that ,turn on your iPhone and go to Setups>>>messages>>>Show subject Field , make it ON

Now Go to messages, it will ask you to put your mobile number , do that . Subsequently , When writing a new message you will find that now the message box has split into two halves .